Volvo RWD S90-V90 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2002 S90-V90 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Check Engine Light on V90--How to Reset and Perform Trip Drive Cycle S90-V90 1998

posted by  weahernut on  Sat Jul 9 21:46 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Does anyone know the procedure for performing the "Trip Drive Cycle" after reseting the check engine light? I replaced a leaking vacuum hose which was causing a Diagnostic Trouble Code (DTC) and then erased the DTC. But the OBD2 code reader now shows flashing monitor icons which indicate a "Has Not Run" status for several of the engine sensors. The OBD2 manual states this means you must now perform the "trip drive cycle" in order for the engine's computer to run it's diagnostic testing.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Check Engine Light on V90--How to Reset and Perform Trip Drive Cycle [S90-V90][1998]
posted by  weahernut  on Sat Jul 9 21:46 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.