Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2001 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Center support bearing 700 1990

posted by  Helmus on  Tue Jul 26 04:11 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I'm in the process of replacing the center support bearing (just waiting for the part) and have a couple of questions. Although I did remember to make alignment marks on the tranny and diff flanges, I didn't for where the two sections of shaft come together. Is that important when re-assembling? I figure as long as both sections are balanced from factory there shouldn't be an issue.
Secondly, there's about a half inch up/down movement when I lift up on the back of the tranny. Seems like alot. Wonder should I replace the tranny mount as well? Thanks in advance.

Elmer 1990 740ti






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Center support bearing [700][1990]
posted by  Helmus  on Tue Jul 26 04:11 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.