Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Head to manifold gasket 120-130

posted by  SebCH on  Tue Aug 2 10:25 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Feb 19 06:25 CST 2010
[RELATED]

Hi!
Next step in my B20E installation: I test-fitted the gasket on the head and the holes in the gasket for the two positionning studs are not so well positionned, so the gasket is a bit "wavy" (ahem, that's the only word (neologism?)I could find...) Should I just ignore this and be confident that when I torque the bolts the gasket will be pressed the right way or should I remove some material from the gasket so it sits nicely on the head? since the gasket is a multi-layer stuff, I'm reluctant to start cutting it! What's my best way out of this?

THanks in advance! Séb






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Head to manifold gasket [120-130]
posted by  SebCH  on Tue Aug 2 10:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.