Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2009 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

brake fluid removal from MC 120-130

uid 17774's pic
posted by  Damian on  Sun Aug 7 03:42 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

My MC rebuild kit (for '68 dual circuit setup) arrived from Sweden yeterday, and I want to perfornm the operation ASAP.

Before removing the MC from vehicle, I'm thinking I need to drain the brake fluid out of reservoir. Not able to suck the fluid out through cap, no turkey baster in sight. I'm assuming that brake fluid would come pouring out of MC, as soon as I loosen up the 2 brake lines running into the thing. OR is that not the case?

Will I have to open up the bleed screws by wheel in order to lower fluid level?

If I'm reading things correctly, Haynes manual suggests draining fluid through the bleed screws at wheel, while my Clymer manual suggests I simply detach the brake lines at MC, remove, and then dump out the fluid.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New brake fluid removal from MC [120-130]
posted by  Damian  on Sun Aug 7 03:42 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.