Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2011 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Oil pressure question for the experts 900 1995

posted by  volvito on  Sun Aug 7 14:21 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Mar 23 04:59 CST 2014
[RELATED]

Got a question that has been bogging me. Probably it is fine, but I am curios about any comments. The engine is a red block B230. There is 4 hollow screws with a spring valve inside in the crankcase that feed oil to the piston rods high end and oil piston ring. This valves open and squirt oil up to the pistons at 25psi, but oil pressure at idle speed can go as low as 15psi. theoretically the valves will no be open at this pressure. And the question is: What is going on at idle speed with no oil for piston rods high end and oil piston ring?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil pressure question for the experts [900][1995]
posted by  volvito  on Sun Aug 7 14:21 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.