Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Driveshaft problems and removal. 200

After stopping at a gas station I get back in and put into drive and push on the gas and nothing happens, then "clunk" and the car goes forward. I've had the problem for 2 years now. Taken it to three shops including Mr Transmission. No one found anything. I've had the rear seal and pinion bearing on the tranny replaced and 2 flushes using the fill while flushing method. I've also replaced the rear suspension components. Tonite I found the center support on the driveshaft was torn and sagging down. The spring under it is none existant. I'm thinking that maybe the cause of the problem. I also checked my U joints.


Do I need to remove the whole driveshaft to replace the rubber mount and is there any tricks in removing it.



Thanks in advance

Chris






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Driveshaft problems and removal. [200]
posted by  archie777  on Mon Aug 15 11:47 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.