Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Volvo 240 DL Superpro Rear Lower Control Arm Bushing (SPF638K) Instructions 200 1986

posted by  rustydog on  Mon Aug 22 05:53 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 9 14:38 CST 2012
[RELATED]

I'm in process of installing polyurathane bushings on my Volvo and am having trouble with the rear lower control arm bushing. The Superpro kit comes with the bushing, tube and washer for each side of the car; and the washer appears to mate with the tapered end of the bushing. However, the diameter of the washer hole is smaller than the inner diameter of the tube. Assuming that the tapered end of the bushing faces toward the front of the car, should I drill the washer to match the inner tube diameter? Or am I just totally confused? Any help would be greatly appreciated. Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Volvo 240 DL Superpro Rear Lower Control Arm Bushing (SPF638K) Instructions [200][1986]
posted by  rustydog  on Mon Aug 22 05:53 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.