Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 Transmission 200 1987

uid 33770's pic
posted by  SportCompactRacer on  Mon Aug 22 17:37 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Okay here we go again, Before you turn the car on, the Automatic (AW70)transmission goes in to gear, you can tell it is in "P", "N", etc. However when the engine is fired, you can slide it in, and the transmission appears to never start spinning, driveline never engages. I tried to the IPD Fluid flush, but with one of the tranny cooler line removed there is no fluid, when so far as to disconnect cooler lines completely from the tranny housing underneath the car, and with it running no fluid comes out. Any thoughts? I was thinking of using something to push the fluid in directly at the housing, seeing if maybe I can force it to push out the other port.

Either that, or does anyone know what manual tranny's will bolt up to a B230F? or is it just the Volvo M45/46/47?

Thanks again
Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 Transmission [200][1987]
posted by  SportCompactRacer  on Mon Aug 22 17:37 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.