Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

rusted rocker panel-removal 200

posted by  volvosfive on  Thu Aug 25 06:25 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 21 08:01 CST 2011
[RELATED]


Would it be okay to take out the rockers on a 240 for replacement if I'm not ready to have the new ones welded in right away? ' Just wanted to make sure that it wouldn't cause a structural problem.I want to clean up the metal inside of the rocker cavity and paint with POR 15 before the new panel goes on. Would POR 15 be beneficial in this area? I'll use weld thru primer on the areas where the metal will be welded. ' Got a new set of rockers for $40 each. I have a handheld sand blaster that I was going to use to remove all of the rust from the inner sill.

Thanks,
Dave






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New rusted rocker panel-removal [200]
posted by  volvosfive subscriber  on Thu Aug 25 06:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.