Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Oil separator replaced 200 1990

posted by  joe pulkowski on  Sat Aug 27 01:01 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 27 07:53 CST 2013
[RELATED]

I replaced the oil separator yesterday, thanks for all the help from the postings, and the FAQ. The job went a lot easier. The old one was full of crude, weighed about twice as much as a clean new one. The car now passes the oil cap rattle test, and seems to have slight suction when i put my hand on the fill hole. The whole job took about two hours, including cleaning a very dirty throttle body.

When I start now, there is a slightly higher RPM, and then it kicks down to idle in a couple seconds after ignition. Is this normal? Idle is a little rough, the car has 240K on it, and its probably time for an injector cleaning.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Oil separator replaced [200][1990]
posted by  joe pulkowski  on Sat Aug 27 01:01 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.