The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

poor idleing- 1995 960 900 1995

Start by replacing the rubber ends on your vacuum lines.along with that replace the long hard plastic line that goes over the front of your engine to the air pump valve. There is a vacuum block on the back side of your intake manifold. Replace all the vacuum ends there as well, replace the larger rubber line that goes up and too the right on the fire wall as well. While your into this vacuum block, there is a 10mm bolt that holds it to the intake. Remove the bolt and take the vacuum block out of the intake,replace the flat O ring on the back with a #30 o ring from lowes hardware.
Next clean the Idle control valve and throttle body as well(check the faqs), after you have done all the above and you still don't have things in order then you should look towards the intake gasket-intake gaskets were upgraded later,your model of 960 seems to have a few problems with them for some reason.
Hope that helps
Poolman






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.