The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Shifter bushings 200 1988

As Bruce near D.C. sez, when the bushings go out or go missing, the shifter gets really sloppy.

There is a bar, adjusable in length, that reaches from the bottom end of the shifter rod that your hand sits on top of to the lever on the transmissin that actually moved the tranny insides.

That lever and back end of the bar have a pin, horizontal and rather fat, that stick through a hole in their counterpart. Not a close fit because there is a bushing around the pin so as to make it snug.

When the bushing isn't there, the pin can rattle about in the hole.

Get new bushings and new clips or fittings that hold the pin in place and do both ends. Takes getting under the car, and can be a bit dirty.

It's a pretty easy job to do. If the clips are still on, be careful not to loose one unless you are smart enough to get a few extras. One end of the long bar has an adjustable fitting, try not to modify the setting.

Good Luck,

Bob

:>)






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.