The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

A/C compressor won't operate; control unit solder problem? 900 1994

My 945T has the manual A/C unit. When I depress the button to turn on a/c, it will be many hot minutes and miles before the compressor kicks in. Once on, it cools pretty well.

During testing in my garage yesterday, with the motor running and the A/C button depressed, I had volts at the low-pressure switch connector, also at the high-pressure switch connector, and at the compressor, but I had no compressor operation.

A visit to the 940 FAQ leads me to believe this is not uncommon. A bad design of the circuit board inside the control unit is the cause, with a re-soldering of certain terminals usually a fix.

My question is: have I done enough testing to rule out other causes, leaving the solder issue the most probable cause?

thx

--
'94 945t; '95 854 base; '05 S80 2.5T






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.