|
Hello,
Well after over 8 hours of hard work, mistakes, and sweat, Inga does have a new operational blower motors. But there are a couple of issues I need your help with.
First the Central Locking does not work at all and it used to. Fuse is good.
There is a blue four pin connector on the right side of the drives side (near the middle) that does not seem to have a mate I could locate last night (central locking perhaps).
There is a loose vacuum line that comes off the drivers side of the bottle to a T connection. It is about five inches long and I could not find a connection for it. It is at the very bottom of the blower assembly.
This was a much bigger adventure that I thought it would be by the way.
Found over a dollar in change in different places including 2 quarters in the duct work. Broke one of the clips that hold the vanes to the motor shaft and had to go to Pick Ur Parts in a driving rain.
Mounted the motor so that is was misaligned becaue of the way I mounted the shunt resistor. That cost me an hour of what the heck is going on.
There will be dash lighting questins later in the week.
Regards,
PT
|
