The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

fuse #16...? 700

As fuses have no polarity, it doesn't matter which wire is which. Remove the wire(s) from one end of the #16 socket and connect them to one side of the new fuse holder. Connect the wire(s) from the other end of the #16 socket to the other side of the fuse holder. Make sure there are no bare wires or terminals that can short against anything. You should have gotten a fuse holder rated for 30A, that has wire leads a few inches long. Run them around the side of the fuse box so the new holder is in an accessible location. Put the dash back together and you're done.

When I did mine I went ahead and replaced the whole fuse box with a good used one, mainly because I had it laying around from a car I had parted out. It was a big job, requiring cutting the mounting lugs off the old fuse box with a hacksaw blade without damaging the black plastic frame it fits into, and the swapping all the wires over to the new unit. As you can probably imagine, this took a good while.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.