The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help crank sensor job is turning into a nightmare 200

What I thought was going to be a quick PM job replacing a deteriorating yellow band crank sensor is turning into a nightmare. Bolt came right out. I then preceeded to try and loosen it by tapping it with hammer and screw driver. It did rotate at first. To make a long story short after about 4 hours of trying everything to get the sensor out all I acomplished was to break the wire of and break about half the top off. Having EGR doesn't help as the pipe tends to get in the way. At the end of the day I sprayed on some PB blaster and wrapped it up. Tomorrow I'll put it on the lift and see if I can get it out from underneath. Its starting to feel like its going to become a rear main seal job.

Is there anyone that can give me some possible ways out of this mess. Would some heat with a propane torch help?






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.