The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 Exhaust Installation 200 1992

I'm about to attempt my own exhaust install (front muffler on backwards). I'm expecting to have to cut the old exhaust off at the front of the front muffler. I'll be going this with no fancy tools (dremel probably to cut)and on ramps. I bought the Starla lit from FCP Groton.

Any advice on how best to install? Do I work backwards leaving everything loose and then tighten. Or should I hang the front and rear mufflers and then attach the axle pipe between the two. Should I use anti sieze compound or anything else.


Also haven't looked hard at this so far, so this may be an obvious question but how do I hang the rear muffler on the rubber mounts. Put the mounts on the muffler at both ends and then just push left and then right? Is there enough play to get the rubber mounts on their mounting points?

Advice welcomed !






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.