The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Exhaust Manifold to Header Studs 200 1993

Hello All,

In replacing my downpipe, two of the three exhaust manifold to downpipe studs came out along with the attached copper nuts.

What is the best way for these two studs to be firmly installed into the manifold so they don't come out?

I don't think there's enough room to use doubled nuts on the studs for insertion as I recall there's not enough room to deal with inserting an open end wrench into the space.

I have red and blue locktite. Would that work?

If I crank a doubled nut with my socket, when I try to get nut no 1 off, I'm certain I'll pull the stud out again cause nut no 1 and nut no 2 won't easily separate.

Any suggestions as I'm sure lots of you have BTDT.

Thanks much,

Marty Wolfson
--
93, 244 141k, 93 244 - 235K (Injured awaiting repair), 93 245 - 172K, 99 v-70 - 112K






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.