The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Regina Oxygen sensor testing 700 1990

"Today, after getting to work a little early, I grabbed a multimeter and measured the voltage on the black sensor lead. With the engine at idle it sat at .004V and did not move."

Sure sounds like a bad O2, if this was testing a warm engine with sensor in "closed loop" (connected to ECU).

The book says the signal "should vary between 0.1V and 1.2V. If consistently low, test it open loop (unplugged) and it "should after a while show approx. 1.2V."

If that 2nd test fails, don't immediately blame the sensor. My own experience (and reading here daily for 5 years) says that the Regina sensor is very long-lived. Maybe even more so than the Bosch type. So look for a break in the signal line. The 0.4V you saw closed loop could have been ECU voltage.
--
Bruce Young
'93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.