The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Headlight Question 120-130 1968

Brad;

The footswitch is a simple device...one wire (Yellow) IN from light switch, two wires OUT (Red for Hi-Beam, Gray for Lo-Beams) use a testlight to verify its function. Both Red and Gray go through 6Pin connector in engine compartment out to headlight buckets. Refer to wiring diagram: http://www.sw-em.com/122S%20Wiring%20Diagram.jpg I recommend locating and remedying the error first, then thinking about changing over to the bistable relay control.

Benski;

The CONTROL of the bistable relay can be performed at the directional signal stalk, but the actual switching takes place at the relay...and that seems to be where the problem is...so adding a bistable relay conversion into the mix now would only add new variables and sources of complexity and uncertainty...I recommend against this.

Cheers






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.