The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Ruined 2 new timing belts 700 1988

Did you examine the cam bearing journals for any embedded aluminum--and on the head the cam saddles for gouging? The cams can and do sieze up for lack of oil (delivery passage along one head bolt crudes up--or the passages in the head itself). If that's the case you can address it without removing the head (wire and solvent and a couple of oil/filter changes). The cam bearing surfaces can be cleaned up with emery cloth--the head saddles too. Is the auxilary shaft spinning freely. The idler pulley shouldn't stop the belt from turning but have you tested/replaced it. Let the idler pulley set the tension--after installing the belt advance the motor a few degrees from the crank pulley to put the slack on the idler pulley side then tighten the lock nut. The bits of rubber under the lifters is what remains of the "cushion". They usually get rock hard with age/mileage and then fall out of place. -- Dave






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.