The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rear main seal's "Chemical Gasket'? 700 1990

They are probably fine, I just use a piece of one of the pads I get at the local auto paint supply store. Just wipe the crank down to remove any residual abrasive tidbits before installing.

Safe to assume you have read this in the FAQ's?
http://www.brickboard.com/FAQ/700-900/EngineSealsBeltsVent.htm#LeakingRearSealandReplacementTips

I install my seals with a piece of PVC. The side against the seal is plane so it sits flush all the way around. I had to cut a section out of it and compress it to the correct diameter. I find the rear main seals to be the most difficult to install, I think it is because as the seal diameter increases it becomes more difficult to get it started into place. It is real easy to get one started in crooked. Go slow and good luck.

Randy

Photobucket






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.