The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Engine ground strap bolt size? Save me some trouble. 120-130

It has been discussed on this forum at length over the years....
It depends on the year and which bolt. For all B18s if the bolt screws into the engine
block the thread is 7/16"-14UNC. You should be using the high-strength bolt that was
already there rather than what you can buy at the hardware store.
If the bolt screws into the aluminum bracket on the lower part of the bellhousing
(1968 or later) used on a few very late B18s and all B20s, the thread will be 3/8"-16UNC.
In this case also the high-strength bolt normally in this position should be used rather
than a hardware store bolt.
For VERY late B20 blocks (which have been used in some re-engine jobs in 122s) the thread size
in the block is M12-1.75 grade 10.9

--
George Downs Bartlesville, Oklahoma






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.