The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Starter button 444-544

Rather than changing coils I would have put a ballast resistor in the circuit between the coil and the distributor.
Normally it is pretty easy to tell which terminal on the starter solenoid is the "start"
one. Most of the 444/544 only had 2, one for the battery cable and one for the "start" wire.
If a later starter has been installed you may have two small terminals on the solenoid.
If so, generally the larger one is for starting and the smaller one is for bypassing the
ballast during starting. But ALWAYS, the start terminal is the one that, when you apply
6 or 12 volts to it, cranks the engine. BTW a 6 volt starter works well on 12 volts.
It may be bad if the engine does not start pretty quick because then the starter may
overheat. But generally more rapid starter operation results in quicker starting.
--
George Downs Bartlesville, Oklahoma






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.