The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

!964 122S, (B-18d) Will not run, after engine rebuild?


Preliminary explanation...Faulty carb. throttle linkage allowed engine to start & run at maximum rpm eventually diluting the oil and ruined the bearings and rings?? the block was previously bored .040" over. The crankshaft and rods were
machined .010" over and fitted with equal size crank and rod brgs. plus .040" Grant piston rings. Pistons were gone over by hand with "scotch guard" and cyls. were honed to clean up some scouring. Had the cyl. head machined .010"
and all new gaskets and seals fitted and torqued to specs. It has new points, condenser, rotor and dist. cap. It has an after market 12V coil and did run o.k. before overhaul. Plugs are firing when cranked with a remote starter sw.
and the ign. sw. to run position. It's wired 1-3-4-2 and dist. rotates C.C.
It started and ran before the rebuild. Fuel pump pressure is good and float levels are normal?
What else is there??






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.