The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Re-fitting a 240 sill mould 200 1992

posted by  Trev29 on  Thu Sep 17 05:38 CST 2015
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 05:56 CST 2014
[RELATED]

"The problem part of the clip is the bottom leg of the plus sign the clip resembles"
I haven't applied them, but have removed them by knocking the shaft (vertical part of "plus sign") into the panel with a punch. That is, the shaft SLIDES in/out of the clip. The new shafts may be stuck in place so appear to be a one piece "plus sign".

So you don't cut the bottom "leg" of the plus sign. Just push it in. Place the clip over the hole and tap the shaft lightly with a hammer until it is flush with the horizontal part. Then, I presume, you snap the trim on.

edit: Looks like Nel61 responded a few minutes earlier, while I was working on the answer.
--
1980 245 Canadian B21A with SU carb, M46 trans, 3:31 dif, in Brampton, Ont.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.