The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

in-tank pump/sender assembly - bung nut tool - borrow - near 22207 200 1988

The bunk nut is not going back on the same way it came off - by hammering into the slots.

The new gasket is obviously thicker. I have lubricated all sliding surfaces of the lock ring and hold downs. I also rigged a squeeze clamp to spread, and using a block, to push down on top of the sender top plate. The bunk nut just bounces off the hold down hooks.

I'm about to take it all apart again and install the original sender seal.

Yes I have the indent on the sender aligned with the tab on the tank.
It looks like ordering bung nut tool will take 2 weeks.

Does anyone in the vicinity of 22207 have a tool to lend?
Does anyone have a way to hack this tool?
- I am looking for a gear puller like Art used. The one I have is too thick to fit in the grooves. ... Maybe I can grind out a wider slot?

Thanks






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.