The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

940 Sunroof Screws

I tried to follow the FAQ to remove the sunroof panel and replace the seal. However, I found that accessing the rear screws with the sunroof in vent position was far easier inside the cabin. The FAQ suggested getting these two screws from the roof.

Also, I bought a sticky-back seal from IPD after calling their sales support and asking which seal was the right seal. Turns out, their seal is too short, and very hard to make work when stretched out.

I abandoned the IPD seal and re-attached the factory seal. The problem was not that the seal was bad or leaking but part of it fell down, which allowed rivers of water into the sunroof mechanism and onto the seat below. To reattach the original seal, I used JB Weld's marine epoxy. So far so good.
--
94 940 n/a 320k+ and rolling, owned 18 yrs; 05 XC90 2.5t for the wife; sold 92 745T; sold 88 764T







USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.