The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Investigating Running temperature lower than expected 200 1985

The gauge sensor doesn't follow the curve used to describe the engine coolant temperature sensor for the fuel system.

The green book specifies 10% tolerance for nominal 282 ohms at 122F, 60 ohms at 212F, and 40 ohms at 248F.

I've made some notes years ago you may find helpful or confusing as hell.



The "test" of the gauge prescribed by Volvo is to substitute a 68 ohm resistor for the gauge sender and expect 3/4 deflection of the gauge. I think 100 ohms puts it right about center, what folks call 9:00.



Check the open-circuit voltage at the end of the yellow wire pulled off of the sensor terminal with key on. Should see 10.0V. Start motor, should still be 10.0V provided by a solid state regulator in the cluster.

--
Art Benstein near Baltimore

A bicycle can't stand alone because it is two-tired.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.