The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Updated Control Arm Stay Rod Cone Bushings -What's the difference? 900

Thank you, Dave.

I am sure the o-ring is well compressed as I use the same procedure you use, with the exception that I have never used any grease, only some vaseline to facilitate the placement when compressing the pump.

I did the head gasket myself 3 years ago, it is all clean, so no oil spill.

I can try the RTV black, but will it be difficult to remove next time?

Regarding the gasket, I have always had a small leak from the bolt at the bottom, I also replaced the bolt, but still a minor leak.
Is there anything I could use to prevent this minor leak from the thread of the bolt?

Finally, the non-drying blue hypalon gasket sealer, any suggestion on the brand you use?

On another note, tomorrow I am flying to Richmond (BC), if I well remember you are in BC, but do not remember where :)

Thank you,
Alex






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.