The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

In deep %$#@ with support bearing HELP! 700 92

posted by  someone claiming to be bob walter on  Tue Jun 5 11:48 CST 2001 [RELATED]

Help! Im at my wits end. I just finished replacing the center driveshft support bearing, carefully marking ALL splines and driveshaft flange bolts for correct positioning when reinstalling. I had the new bearing carefully pressed into the new rubber housing then pressed onto the drive shaft. Now, I have a bearing noise that starts at 25 mph and goes away when I take my foot off the gas. Is it too far for or aft? I was not quite sure how to best align the shaft sideways due to the the slotted holes in the support plate. Any knowledgeable ideas here? Is there a specific way the bearing goes on the shaft? I also realized I left the metal plate that goes on first, although I dont think this has any value.





USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.