The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How to remove Center Bearing from Driveshaft?!?! Help 700 1987

posted by  someone claiming to be Napoleon on  Wed Mar 13 02:11 CST 2002 [RELATED]

Follow the directions below. 'tis most important to mark the splined joint between front and rear sections. I also mark the yokes at the Ujoints. A brass punch and MFH work fine for me when I drive the old bearing off and the new one on. Careful to hammer only on the inner race-the part that fits around the driveshaft. Be sure to drive the bearing all the way on, until it seats against the shoulder. On the other hand, if you don't have a lot of experience installing bearings, you may want to take it somewhere. The job isn't too sophisticated, though.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.