The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

strut replacement 200 1988

The flat rate for each side is about 1 1/4 hours, so two and a half for both. The upper mount is removed to do the shock, so there is no extra labour for that part to be replaced.
Monro-matics in Canada retail for about $210.00 the pair, so I do the job for about $350 without the mounts.
Air tools help a lot, especially with the spring compressor. But one slip with the compressor and you can ruin your whole day. Rent or buy a good one if you do the job.
Disconnect the brake line bracket, the tie rod end, the sway bar link, and mark the upper mount location on the inner fender. Remove the three nuts, and lower the strut down, and angle it out of the fenderwell. Install the compressor, and squeeze the spring down until it is loose. Remove the upper shock nut, the plate, and the shield, and the spring. Install the new shock in the strut, and reverse. With a good compressor it is not that bad of a job. Takes me about 30 -45 minutes a side when all goes well.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.