The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

rear signal 200 1989

No problem, I figured I better ask. I know the sedan better. The ground for
the tailights should be a wire coming off the printed circuit vinyl and attached
to a screw in edge of the rear panel. Once you take the plastic cover off the
tailight you should see the ground wires screwed down there. The right side of
the car has two wires grounded there and the left side one. If your lights
are screwed up it could be where the wiring harness attaches to the light. The contacts on the printed circuit card get burnt or corroded. The vinyl printed ciruit card is available separately for $20 from newandusedvolvoparts.com as well as FCP Groton and other board advertisers.

Some corrosion killing contact spray like Wurth Contact DL is good for cleaning
the contacts on the vinyl and not being abrasive to it. Make sure the light bulbs are matched from side to side that way the bulb out light on the dash will work. Hope this helps you.

Dave 82 242ti 273k mi.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.