The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

engine pinging under load 200

My 240 Engine experience is primarily with B230F units, but I suspect the following will apply to all injected 200's. It sounds like the knock sensor may be bad which would cause the ECU to excessively advance the timing... and eventually fry the valves. Besides replacing the the sensor with a new one, the best test is to set the idle up to about 1500 RPM or so, and hit the upper passenger side of the block with a metal object (perhaps a hammer or pipe). You will also need to have a timing light hooked up and pointing at the timing marks. When you hit the block, you should see the timing back off for a cycle or two, if it doesn't, either the knock sensor or its harness is bad.

Until this problem is resolved, you should MINIMIZE the driving / NOT DRIVE the car as it will tear up the valves and seats if it is knocking. A knock sensor is a LOT cheaper than a complete valve job!

Later,
John
1990 240DL Sedan Auto






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.