The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Don't pull on those injector wires!!!!!!!!!

If you examine the small clips carefully (which is obviously tough to do when they're still in the plastic housing) you'll see a tiny tab on the clip that snaps into a recess in the plastic housing. This tiny tab effectively locks the connector clip into the housing.

Using a very small jeweler's screwdriver and working from the front of the housing (the wires go in the rear) you can bend this tiny tab down, allowing the connector clip to slide out the back of the housing.

Once you've soldered the wire onto the connector clip, bend the tab upward to about a 30-degree angle and insert the clip into the plastic housing. The tab should again snap into the housing, locking it in place. Be aware that the clip must be oriented properly so that the tab mates with its recess.
--
Don Foster (near Cape Cod, MA)






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.