The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Intake vent screen 700 1988

Remove both wiper arms by lifting the plastic cap over the spindle and undo the nut which holds the arm onto the spindle. Do this with the arms in the parked position so you know where to position them when refitting. Pull off the spindle to panel rubber seals.
Open the hood and you will see three bolts holding the panel to the firewall, remove these and lift the front of the panel up and forward towards the rear edge of the hood, it will unhook from under the windshield and lift off. The mesh screen is just glued to the underside of the panel with some black muck.
Clean it up and re-glue with something suitable.
Reassembly is the reverse of dismantling as the books always say.
A good idea would be to put masking tape on the rear 3inches or so of the hood to avoid paint damage.
Hope this helps, Colin.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.