The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Brake Booster 1800 1965

Here is the DOT-3 question: I just finished the brakes, front disks (new seals), rear cylinders replaced with new units, master cylinder new seals. All lines did not apear to have any leakage. I installed the master cylinder (after bench bleeding) and filled it about 3/4 full. The brakes have not been bled yet and all bleeder valves are closed and tight.
I decided to run the motor for a while (15 minutes) and do some timeing, and carb adjustments. After turning off the engine, I checked the master cylinder and it was down by 1/2 of the fluid.
Based on the age of the vehicle, and having been stored for 18+ years, I was hopeing the booster might still be good. Is it the opinion of this forum that the break fluid was vacuumed into the motor?
Is there a way to check to see if the brake fluid is going into the vacuum while the motor is running? I pulled the vacuum line off expecting to see wetness, but things were dry.
Thanks, I'm Havinfun.






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.