The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1986 B230FT 700

Hi All:

Just thought I'd pass this on to anyone thinking of rebuilding a B230FT with the Center Thrust Bearing. I've finished installing my 92 B230FT into a 1986 Turbo Wagon with 4 Speed O.D.

This was the direction I was told to go, on this board, as the 1986 engine was weak. Thanks guys, it paid off.

I decided to disect the 1986 engine to see how sick it was. Here goes:

(1)- Over .030" Bore wear.

(2)- Over .008" wear on the Rod Bearings (Down to the Copper Backing)

(3)- No Thrust Bearing (It fell into the pan). It looked like over 1/8" Crankshaft endplay.

(4)- Center Main Bearing spun, with the bore badly scored.

As you can see, this baby was sick. But it was till running with no Oil Smoke and pretty good Compression. This is quite a tribute to Volvo. Even with a bad design!!!! I replaced it beacause of excessive blowby, a leaking Rear Main Seal, low Oil Pressure and bearing noise. But still running at 70 mph on the highway!!!

Thanks
Warren






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.