|
Fuse should go before wiring. Check that fuse is the proper size.
The motor is obviously drawing too much current which means that the motor is bad or something is binding in the window lift mechanism. Note, that this does not mean you could not have a short, but if it only happens when trying to operate the window, then more than likely the motor or mechanical problem.
You can remove the door panel to check it out. Pop out plugs that cover screw holes on door handle. Remove two door handle screws. Unscrew too look button. Remove half turn plastic fasteners of door pocket. Remove screws that hold door pocket ends (door pocket slips over them). Gently pry clips loose around door edge (use flat head screw drive at point where you can feel clips), hopefully not breaking them. Rotate the back section of the door about 45 degrees, which will release the panel from the door (at the door handle). There is a metal tab that fits in a slot which is at an angle; this is why you must rotate the panel. Be careful not to pull wire off the speaker when removing panel. If you lucky the speak will have push on connectors rather than soldered.
Gary
|
