|
87 245 B230 CDN model - manual 5 spd
This 245 was stalling/sputtering occasionally over the past several months. I thought it may have been bad gasoline........
With your information recently, I took a look at some areas that required maintenance.
Yesterday, I removed and cleaned the throttle body, checked for vac leaks, and removed and cleaned the IAC valve.
Both were very dirty.
I thought the problem may have been solved - car ran smmooth - but then again it does most of the time.
This morning, my wife took the car through a brushless car wash - and did the undercarriage spray option. then she called me from inside the car wash - car would not start and she missed the "dryer" cycle.
She had tried to start the engine at least 6 times. no firing.....
After I calmed her down, I had her call the attendants, and they pushed her car out of the carwash.
She let it sit for about 10 minutes out in the wind (about +40f) then called - it started. At first it was "bucking like an old tractor" (her words) - then smoothed out. And runs normal as of this writing (she is still in town)...
To her credit - the fearless gal still had some shopping to do - rather than scurry right home.... :)
However - I do not know where the fuel pump relay is located, nor what it looks like. - there are several relays tucked up under the dash......
Last postings - someone suggested the fuel pump relay may need re-soldering.
Where is the fuel pump relay located, and what does it look like.
Thanks in advance..
G
|