The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

bodywork question, recreating a seam 120-130

When my replacement rear quarter panel was attached to car, shop neglected to keep both seams which go between body panels. Yellow arrow indicates seam I am describing, red arrow shows where there is supposed to be one.

Think it's possible to recreate seam with grinder or something? After looking at repair from inside trunk, I'm concerned how the repair was carried out. I can't tell if the panels were welded together (I hope not!); something sure doesn't look right. I'll get some digital pics of repair from inside trunk and post next week.

Going to have to tackle this area again anyways, the paint has begun cracking in approximate area where seam should be, not good (especially since I towed car out of autobody shop only a few weeks ago).

Oh yeah, the silver metal piece which holds tailight bulbs has now been installed correctly (from the inside, not on outside as shown in pic).







USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.