|
And I'm sorry for misreading your post. Here is something you can try for openers. It's from my "canned responses".
===================================>>>
O2 Sensor/ECU Rich/Lean Test
This test is described in the the Bosch FI & Engine Management manual (p 6-22, "Rich stop" and "Lean Stop"), for Continuous Injection (CI) K-jet, but also described as being applicable to LH injection in the Volvo Problem Solver. I have used it on both systems, and offer it as a way to verify the sensor/ECU responses.
O2 sensor/ECU interaction can be tested by sending simulated Full RICH and Full LEAN O2 sensor signals to the ECU, and watching for appropriate responses from the O2 sensor. This is done "Open Loop", (i.e., with the O2 sensor signal unplugged), and with Voltmeter connected the O2 sensor lead. The engine and O2 sensor should be fully warmed up for this test.
Full Rich Test: Apply a + voltage potential to the ECU Green wire. Use either the + terminal of a grounded 1.5 volt (Flashlight) battery. Or, if you have Orangutan arms, hold the ECU (green wire) terminal with one hand and put the other hand on the Battery Positive terminal. The ECU should see this as a "Rich" O2 signal and respond by setting a very lean fuel mixture. The Idle should worsen (may even stall), and the O2 sensor should respond with a correspondingly low output (0.1 to 0.2 volts).
Full Lean Test: Ground the Green wire going to the ECU (I use the braided ground on the valve cover). This simulated "O2 Lean" signal should result in very rich setting from the ECU . The RPMs should increase, and the O2 sensor output should rise to nearly a full 1.0 volt.
<<<=========================================
--
Bruce Young
'93 940-NA (current) — 240s (one V8) — 140s — 122s — since '63.
|
