The message to which you are about to reply is shown first. GO TO REPLY FORM



 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Who's Temba?? 120-130

Clamp the nut in your vise the thin way, with one corner of the hex sticking
up. File right into that corner making a round-bottomed groove 5/16"+ wide and
deep enough that when you stick a bolt through the groove it will screw into
one of the tapped holes in your steering wheel. Do the same on the opposite
corner of the nut. When you get it to where the bolts will JUST fit through
the grooves and screw into both holes, you're done filing. Bolts must be the
right length so that you have enough thread engagement not to strip the threads
but not bottoming out. Use flat washers between the bolt heads and the big
nut, and put the nut just to where the end of the steering column is flush with
the surface of the nut. Then when you tighten the bolts up it will pull the
wheel against the column.
--
George Downs Bartlesville, Heart of the USA!






USERNAME
Use "claim to be" below if you don't want to log in.
PASSWORD
I don't have an account. Sign me up.
CLAIM TO BE
Use only if you don't want to login (post anonymously).
ENTER CAPTCHA CODE
This is required for posting anonymously.
OPTIONS notify by email
Available only to user accounts.
SUBJECT
MODEL/YEAR
MESSAGE

DICTIONARY
LABEL(S) +
IMAGE URL *
[IMAGE LIBRARY (UPLOAD/SELECT)]

* = Field is optional.

+ = Enter space delimited labels for this post. An example entry: 240 muffler


©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.