|
Thanks Jessie. Here's what I have:
Control unit is silver, part number 3523537. Eight wire plug plus one female spade. Six wires go from the clear plastic plug and 1 from the spade to the black harness plug as follows:
#1 green /yellow
#2 orange
#3 yellow/ red
#4 blue/yellow
#5 yellow
#6 Black
#7 red/blue
#8 vacant
Same wires exit the other side of the black plug, for which I have the plug and harness also. Three leads from the "out" side of the plug already connected to the pump. Ground from "out" side connected. I have been unable to locate any harness plug already in the car that would just plug right into the control unit. If it were there, there should also be a plug or junction to go to the vacuum pump, but no sign of that either.
Orange, green yellow and red yellow. These were wired via a separate harness to the vacuum pump. Reconnected the same way.
White black and blue black are on a separate lead to the pedal plug. Done.
There is a third plug from the control unit that plugs into the stalk switch (from same donor). That's also connected. No leftovers to account for the blue/yellow from the black 8 pin plug!
From the "out" side of the black plug that leaves the blue yellow, the red blue and the yellow. The yellow has a female spade on it, but no terminal on the back of the instrument cluster to plug it into (I remember there was one on the donor.)
I have spliced into the black/blue on the speed connector with a male spade terminal waiting for a friend to connect to. To the yellow female spade?
Thanks again to anyone to can help!!!
DS
|