Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

float bowl (carb) leak problem 120-130

posted by  walrus3 on  Mon Nov 28 09:04 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

It would be a LOT easier just to take off the affected carb and see if you
can put it back together. It is the tube that goes from the float bowl to
the jet and is actually part of the jet. With CARE, you can put it back
together but you gotta carefully remove the rubber ring that fits around the
metal tube and is held in place by the fitting that screws into the bowl bottom.
Put the tube back through the fitting, put the ring around it, and screw the
fitting back into the bowl while holding the tube in. Once the fitting gets
tight it should stay OK and not leak. Then you can put the carb back on.

It'll be easier if you take off the air cleaner(s) first.
--
George Downs Bartlesville, Heart of the USA!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New float bowl (carb) leak problem [120-130]
posted by  someone claiming to be rainy_NW  on Mon Nov 28 06:13 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.