Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2012 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What is the bolt/thread size of the panhard (stabilizer) bar mounts? 444-544

posted by  Ron Kwas on  Fri Jan 6 11:11 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:03 CST 2014
[RELATED]

jn;

Just measure the threaded stud OD...I don't have one in my hand right now, but I know they're not UNF (and pretty sure they're not 13mm Metric)...if yours are castelated nuts (requiring cotter pins to secure) you could certainly replace them with nylock type, but it scares me a bit when you say that the nuts are bunged up enough, I hope that the associated threaded studs of the mounts are not equally bunged up...you might want to chase the threads to clean them up...
use Anti-seize to reassemble!
Cheers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What is the bolt/thread size of the panhard (stabilizer) bar mounts? [444-544]
posted by  jnshk  on Fri Jan 6 10:57 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.