Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 9/2008 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Grinding/clicking noise when engaging the indicators 200 1991

posted by  Aye Roll on  Wed Mar 8 05:15 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 14 21:08 CST 2014
[RELATED]

Remove the console side kick panel adjacent to the driver's right foot.
The turn signal relay is a black box hanging in there. Could be just below the edge of the carpet, but it lives with all the other harnesses along the center tunnel.
If you'd like to rule it out, pull the fuse for the turn signals. IF I'm not mistaken they're on the same circuit as the seat heaters- an older car used to blow the fuse for these due to the switches being adrift in a cracked center console. Turn signals went with them.

HOwever this sounds also like it may be a heater fan going bad. They definitely make awful noises and even on the lowest setting they try to run. Try pulling the heater blower fan fuse.

Good luck wi r
--
Rob Bareiss, New London CT ::: 87 244DL- 249K, 88 245DL- 181K, 84 242DL, 89 244DL parts, SOLD: 86 244, 88 244GL, 87 244, 91 244, 82 245T, 88 744GLE, 86 244






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Grinding/clicking noise when engaging the indicators [200][1991]
posted by  Volvo244Life  on Wed Mar 8 04:53 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.