Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

testing out the blower motor after installing 200

posted by  B.C. on  Mon Apr 10 21:06 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

You can probably test it with other stuff still unhooked. BUT - be certain that no wires are laying around touching things they shouldn't.

There may be another way. The motor has only two wires, hot and ground. Connect the ground, and disconnect the hot (red) from the switch. Run a jumper wire from a hot source, and see how it spins the motor. If you use the fuse panel for the hot source, be careful as there are some hot all the time circuits in there.

Maybe the battery jumper cables, hot connected only, with the hot clamp sitting on a front floorboard. Then a short jumper for connecting to the motor red would be easier.

Hope it works OK.

Bob

:>)





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New testing out the blower motor after installing [200]
posted by  MoncureWW  on Mon Apr 10 16:03 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.