Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Thanks very much..... 200

posted by  Ken C on  Wed Apr 19 16:27 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:39 CST 2014
[RELATED]

re: "...Then whack the snot out of the bushing from behind with a 2 pound sledge...."

Yes, you're right -- I was referring to those large ones (about 2 inches wide) at the rear/tail ends of the front A-arms.

The IPD video shows merely using a hammer and drift to remove the smaller front bushings and a vise to reinstall new ones -- but it made it seem that it requires a press to remove the old, large one that I was asking about. Glad to hear that a sledge would suffice.

Much appreciated.
Best regards,





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need advice, please, on installing front Poly bushings.... [200]
posted by  Ken C subscriber  on Wed Apr 19 13:00 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.